Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision |
drawingchecklist [2018/05/28 07:36] – [lines] correct slope l-size description brucemutton | drawingchecklist [2018/09/22 23:30] – minor height clarification brucemutton |
---|
subtype moonmilk | subtype moonmilk |
subtype ice | subtype ice |
subtype # pit height 10m ##usually refers to pit from surface, not underground pit or shaft | subtype # pit -height [10 m] ##usually refers to pit from surface, not underground pit or shaft |
| |
subtype invisible | subtype invisible |
| |
''__line label__ -text "Label Text" # -scale s'' ## Line label gives you text fitted to the curve and length of the line. If the line is longer than is necessary for the specified size (text height), then the characters are spaced out to fit the line. If the line is too short, the text size is reduced so that the text will fit. see also [[drawingchecklist#points|Point Label]] \\ | ''__line label__ -text "Label Text" # -scale s'' ## Line label gives you text fitted to the curve and length of the line. If the line is longer than is necessary for the specified size (text height), then the characters are spaced out to fit the line. If the line is too short, the text size is reduced so that the text will fit. see also [[drawingchecklist#points|Point Label]] \\ |
''__line pit__'' (or ''line wall:pit'') ''-height [+10 m]'' ## -ve and ? values not allowed for some reason. Height only displayed with some symbol sets \\ | ''__line pit__'' (or ''line wall:pit'') ''-height [+10 m]'' ## -ve and ? values not allowed, as they are for ''point height''. At present, only AUT symbolset responds to height, by filling in triangles where height > 20m \\ |
\\ | \\ |
''__line section__ # -direction begin -direction end -direction both -direction <point>'' ## If both bezier control points are active, they individually control length of displayed section line. For drawing cross sections, see [[drawingchecklist#scrap|scrap]] and [[drawingchecklist#points|point section]] above.\\ | ''__line section__ # -direction begin -direction end -direction both -direction <point>'' ## If both bezier control points are active, they individually control length of displayed section line. For drawing cross sections, see [[drawingchecklist#scrap|scrap]] and [[drawingchecklist#points|point section]] above.\\ |
''__[[drawingchecklist#wall|line wall]]__'' \\ | ''__[[drawingchecklist#wall|line wall]]__'' \\ |
''__line floor-step__'' \\ | ''__line floor-step__'' \\ |
''__line pit__ # -height 10m'' ## pit or shaft within the cave, not from surface\\ | ''__line pit__ # -height [10 m] '' ## pit or shaft within the cave, not from surface. At present, only AUT symbolset responds to height, by filling in triangles where height > 20m\\ |
''__line floor-meander__'' \\ | ''__line floor-meander__'' \\ |
''__line slope__'' # must specify l-size for at least one line point, and optionally orientation at one or more line points, ''-border on'' ## to get a line at the top edge\\ | ''__line slope__'' # must specify l-size for at least one line point, and optionally orientation at one or more line points, ''-border on'' ## to get a line at the top edge\\ |