This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revisionBoth sides next revision |
drawingchecklist [2019/11/14 09:55] – [station] each scrap needs two stations brucemutton | drawingchecklist [2020/08/24 05:56] – [lines] brucemutton |
---|
''__line pit__ # -height [10 m] '' ## pit or shaft within the cave, not from surface. At present, only AUT symbolset responds to height, by filling in triangles where height > 20m\\ | ''__line pit__ # -height [10 m] '' ## pit or shaft within the cave, not from surface. At present, only AUT symbolset responds to height, by filling in triangles where height > 20m\\ |
''__line floor-meander__'' \\ | ''__line floor-meander__'' \\ |
| ''__line gradient__'' \\ |
''__line slope__'' # must specify l-size for at least one line point, and optionally orientation at one or more line points, ''-border on'' ## to get a line at the top edge\\ | ''__line slope__'' # must specify l-size for at least one line point, and optionally orientation at one or more line points, ''-border on'' ## to get a line at the top edge\\ |
''__line contour__ # -gradient <none|center>'' ## to specify no tick marks, at centre only,eg | ''__line contour__ # -gradient <none|center>'' ## to specify no tick marks, at centre only,eg |